Qm set 100 -virtio3 /dev/disk/by-id/ata-WDC_WD80EFAX-68LHPN0_7SGK1PGCĬonfirm via 'cat /etc/pve/qemu-server/100.conf' After install, shutdown VM.Īdd the two devices to the VM as passthrough. Note that 'ls /dev/disk/by-id' will show each disk ID and a link to the /dev/sd?Ĭreate FreeNAS VM on PVE. Tell PVE to use tank/vmdata for VM and Container storage. Zfs set compression=on tank Tell PVE to pickup the storage Shows all zfs filesystems -> the single pool 'rpool' plus the other zfsįilesystems that PVE created for its use.Īta-WDC_WD80EFAX-68LHPN0_7SGJ4H6C /dev/sddĪta-WDC_WD80EFAX-68LHPN0_7SGK1PGC /dev/sde Therefore, it's important not to change device locations. Theseĭevices are assigned based on when and where drives are inserted/removed. Note that this creates the pool 'rpool' with /dev/sda and /dev/sdb. Router, configured as bridge w/ static IP: 192.168.88.9 IĬonfigured the DRAC to have an IP address of 192.168.88.30. The DRAC provides a means for out-of-band management of the R610. I'm using a Dell R610 server with 64MB of memory. Possible duplicate content with plex-ubuntu-proxmox Server Hardware

Plex media server ubuntu 16.04 setup